Home / Seven Ways a Fence Post Goes Wrong Before the First Panel Goes Up
Seven Ways a Fence Post Goes Wrong Before the First Panel Goes Up

A fence post usually fails months or years before anyone notices, and the cause is almost always something that happened in the first hour, when the hole was dug and the concrete was poured. The panels get blamed, the stain gets blamed, the wind gets blamed. The post was already set wrong.
Most of these mistakes cost nothing extra to avoid. They only require knowing what the buried part of a post is up against.
The Buried Half of the Fence
Everything visible on a fence is cosmetic compared with what is underground. The post carries the wind load, the weight of the panels and the pull of a gate. It does that through a few feet of soil and a column of concrete, and in Edmond that soil is often red clay that swells in wet weeks and shrinks in dry ones. Add hot summers, the occasional hard freeze and spring storms that bring strong straight line winds, and a solid privacy fence in a typical Edmond backyard behaves like a sail on a lever.
A post that is set well handles all of that. A post that is set carelessly shows it in one of three ways: it leans, it wobbles, or it rots at the ground line.
Mistake One: The Hole Is Too Shallow
A common rule of thumb puts roughly a third of the post's total length underground. Crews and homeowners shorten that to save digging, and the result is a post with too little grip on the soil.
Shallow posts lean first on the windward side of the fence, usually after a storm, and they lean in the direction the panels catch the most air. Once a post starts to tilt, the panels pull on the neighbors and the whole run starts to sag.
A worked example
Take a six foot privacy fence:
- Six feet of post stands above grade.
- Following the one third rule, the hole needs to be about three feet deep, which makes the post nine feet long overall.
- A post cut to eight feet would leave only two feet buried, so the fence looks identical on day one while holding far less.
The shortcut is invisible until the first hard wind, which is exactly why it keeps happening.
Mistake Two: The Hole Is Too Narrow
A hole dug barely wider than the post leaves a thin sleeve of concrete around it. Thin concrete cracks, and a cracked footing lets water travel straight down to the base of the wood. A wider hole, commonly about three times the width of the post, gives a footing that resists tipping and stays intact through freeze and thaw. How hole depth and footing shape work together is covered in more detail in an earlier post on post setting.
A post auger that matches the post size is not the right tool for a fence that needs to survive wind. Go one size up.
Mistake Three: Lumber Not Rated for Ground Contact
Treated lumber comes in different grades, and only some are rated to be buried. Boards that are treated for above ground use look the same at the lumberyard and cost the same effort to install, but they rot sooner in wet soil. The rating is printed on the tag stapled to the end of the board, and it is worth reading before a single post goes in the ground.
Posts that rot from the base inward can look sound from above for years. That is why the screwdriver test at the ground line matters.
Mistake Four: Flat or Dished Concrete Collars
Posts fail at the base first because water collects where the post meets the soil, and wood rots from there. A concrete collar that is flat, or worse, slightly dished from careless troweling, holds a ring of standing water around the post every time it rains.
The fix takes about a minute during the pour: slope the top of the concrete away from the post, like a very low cone, so water sheds outward. It is one of the cheapest details in fence building and one of the most commonly skipped.
Mistake Five: Nothing Under the Post for Drainage
In heavy clay, a hole can act like a bowl. Water enters from the surface and has nowhere to go. Gravel at the bottom of the hole gives that water a path out and keeps the end grain of the post from sitting in a puddle. Setting the post directly on clay and pouring concrete around it traps moisture against the wood from the bottom up.
Mistake Six: Ignoring the Clay
Clay moves. It swells when wet and shrinks when dry, and that cycle can push or tilt posts a little each season. A fence set in a wet spring can look perfect, then shift in a dry August as the soil pulls away from the footing and leaves a gap.
Nothing fully stops clay from moving, but a deeper hole, a wider footing and good drainage all reduce how much of that movement transfers to the post. Planning for the soil is better than being surprised by it.
Mistake Seven: Skipping the Plumb Check While the Concrete Is Wet
Concrete sets quickly, and a post that is out of plumb when the pour starts stays that way. Check it with a level on two adjacent faces, brace it, and check again after the concrete is in, because pouring and tamping can nudge it. A post that is off by a small amount at the base looks off by a lot at the top of a six foot fence.
Mistakes at a Glance
| Mistake | What it looks like later | What prevents it | |---|---|---| | Shallow hole | Lean toward the wind after storms | Bury about a third of the post length | | Narrow hole | Cracked footing, wobble | Dig wider than the post, commonly about three times its width | | Wrong lumber grade | Soft wood at the ground line | Read the ground contact rating on the tag | | Flat concrete collar | Dark, damp wood at the base | Slope the concrete away from the post | | No drainage gravel | Rot starting from the bottom | Gravel under the post | | Ignoring clay | Seasonal gaps and tilting | Depth, width and drainage working together | | No plumb check | Crooked line from day one | Level on two faces, before and after the pour |
A Five Minute Check That Catches Problems Early
Fence posts rarely fail without warning. A short walk once a year, ideally after the wet spring stretch and again after a dry summer, catches most of what is going wrong.
- Push each post by hand. A solid post barely moves. A post that rocks has a loose footing or rotted base.
- Look at the ground line. A gap between the post and the concrete, or dark, damp soil at the base, means water is getting in.
- Hold a level to it. A post that was straight last year and is tilted now is moving, and it is worth knowing which way.
- Probe the wood. Push a screwdriver into the post right at the ground line. Firm wood resists. Soft wood that gives easily is rot, even if the top looks fine.
Mark any post that fails one of these checks with a piece of tape. Two or three suspect posts in a long run are far easier to deal with than a whole section that has started to lean.
Planning a Fence Beyond the Posts
For readers comparing fence materials, styles and local conditions, fences edmond review collects the practical questions that come up most often before a fence goes in.
The Short Version of Doing It Right
A post set properly is deep enough to resist the wind, wide enough to stay intact, made of lumber rated for burial, drained at the bottom, sloped at the top and plumb on the day it was poured. None of that is complicated. It is just easy to skip when the goal is to see panels going up by the end of the day, and that is exactly when the next five years of the fence get decided.